内热型超声雾化溶液再生系统最优内热量的研究

基于质量守恒、能量守恒定律，建立了内热型超声雾化溶液再生系统（IH-UARS）的再生性能预测模型并进行了充分的实验验证，通过研究不同内热量下IH-UARS的再生性能及其变化规律，寻求系统所需的最佳内热量并明确其可能的影响因素。结果表明：IH-UARS系统存在最优的内热量范围，使其再生系统性能最佳；所需最优内热量随着再生溶液流量增大呈显著的对数增长，但受空气流量的影响较弱；在该研究中的标准工况下，IH-UARS所需最优内热量约为275~350 W。此外研究发现：内热量的增长有益于促进初始浓度较高的溶液进一步浓缩再生，如当IH-UARS中内热量增至800 W时，其初始浓度为36%的溶液比24%的溶液浓度增量指标改善幅度高37%。研究所得结果可对提高溶液再生性能及经济性提供积极参考。     

Room Temperature Ferromagnetism in Co-doped CuAlO2 Nanofibers Fabricated by Electrospinning

One-dimensional, diluted magnetic semiconductor nanofibers have attracted increasing attention for their unique magnetic properties, large specific surface area, and high porosity. These qualities lead to excellent performance in magneto-optical devices, magnetic resonance imaging, ferrofluids and magnetic separation. The purpose of this study is to fabricate P-type one dimensional CuAlO2-based diluted magnetic semiconductor nanofibers. First, we fabricated Cu Al0.95Co0.05O2 nanofibers with an average diameter of 1 μm with the electrospinning method. The annealed nanofibers were thermally treated at a temperature of 1 100 ℃ and then shrunk to a diameter of about 650 nm. We used X-ray diffraction measurements and Raman spectra to confirm that the Cu Al0.95Co0.05O2 nanofibers had a single impurity free delafossite phase. The X-ray photoelectron spectroscopy analysis indicates that Co was present in the +2 oxidation state, resulting in an room temperature ferromagnetism in the Cu Al0.95Co0.05O2 fiber. This contrasts with nonmagnetism in pristine CuAlO2 fiber. The coercivity(Hc) value of 65.26 Oe and approximate saturation magnetization(Ms) of 0.012 emu/g demonstrate good evidence of ferromagnetism at room temperature for Cu Al0.95Co0.05O2 nanofibers.     

Hopping transport in the space-charge region of p-n structures with InGaN/GaN QWs as a source of excess 1/f noise and efficiency droop in LEDs

Semiconductors - It is shown that the emission efficiency and the 1/f noise level in light-emitting diodes with InGaN/GaN quantum wells correlate with how the differential resistance of a diode...     

AP1000稳压器波动管竖直管段空气-水CCFL实验研究

使用竖直管代替波动管模型开展稳压器波动管竖直管段内空气-水两相逆流限制（CCFL）特性可视化实验研究。实验现象表明:竖直管与上容器接口处的局部CCFL决定了进入竖直管内的液相流量；竖直管内的局部CCFL决定了从竖直管流出的液相流量；两处局部CCFL均随空气流量的增大而增强。在较低气量情况，进入竖直管内的液相能够完全或大部分流出，竖直管内的局部CCFL较弱，上容器和竖直管接口处的局部CCFL在整体CCFL中占主导地位，整体CCFL程度随着上容器液位升高而略有增强。在高气量情况，从上容器进入竖直管的液相大部分或者完全被限制而不能向下流出，竖直管内的局部CCFL强烈，在整体CCFL中占主导地位，整体CCFL特性不受上容器液位变化的影响。通过实验数据拟合得到了新的稳压器竖直管CCFL模型。稳压器波动管CCFL数据和稳压器竖直管CCFL数据基本重合，表明波动管CCFL主要由CCFL-U决定。      

基于哈希链的软件定义网络路径安全

针对软件定义网络中，控制器无法保证下发的网络策略能够在转发设备上得到正确执行的安全问题，提出一种新的转发路径监控安全方案。首先以控制器的全局视图能力为基础，设计了基于OpenFlow协议的路径凭据交互处理机制；然后采用哈希链和消息验证码作为生成和处理转发路径凭据信息的关键技术；最后在此基础上，对Ryu控制器和Open vSwitch开源交换机进行深度优化，添加相应处理流程，建立轻量级的路径安全机制。测试结果表明，该机制能够有效保证数据转发路径安全，吞吐量消耗比SDN数据层可信转发方案（SDNsec）降低20%以上，更适用于路径复杂的网络环境，但时延和CPU使用率的浮动超过15%，有待进一步优化。     

画意真山与胜景无穷——北海镜清斋假山营造思路的再认识

进入更广泛的历史语境探讨清乾隆时期镜清斋假山的营造思路,追溯至晚明江南的两种假山营造来源.在整体构思上,承续了17世纪前期张南垣所创的追求画意真山的"天然"假山;而在局部营造中,则采纳了16世纪后期盛行的追求胜景无穷的"人巧"假山.除镜清斋之外,在稍晚的苏州环秀山庄假山中也有显著表达,是清代假山发展高峰的体现.清末和1970年代对该假山的两次改造,未能很好理解原初的思路取向,一定程度上损害了当初追求的山意.     

In situ characterization of LiY(WO4)2 nanotubes for electrochemical energy storage

Here, LiY(WO₄)₂ nanotubes are prepared via a feasible electrospinning technique. This new anode material shows excellent electrochemical properties. The capacity loss of LiY(WO₄)₂ nanotubes is as low as 6.9% after 156 cycles, while bulk LiY(WO₄)₂ presents the capacity loss higher than 55.0%. Even after 600 long-life cycles, the capacity loss of the nanotubes is only 9%. It can be seen that the hollow structure with a rough surface and a porous morphology contributes to the improvement of electrochemical performance. Furthermore, online X-ray diffraction (XRD) method is firstly applied to understand the lithium ions insertion/extraction mechanism of LiY(WO₄)₂ nanotubes. It can be concluded that it is an asymmetrical two-phase reaction. A phase transformation from LiY(WO₄)₂ to Li₃Y(WO₄)₂ can be obviously seen from the in situ XRD during discharge process. While Li₂Y(WO₄)₂ appears as an intermediate phase with a reverse charge reaction. In addition, in situ XRD also demonstrates that LiY(WO₄)₂ nanotubes have surprised electrochemical reversibility. All the above results indicate that LiY(WO₄)₂ nanotubes can be expected to be anode candidate for rechargeable lithium ion batteries (LIBs).